KNOW YOUR ROTARY TOOL & ACCESSORIES
No. Accessory Explanation & Applications
1 Collet (Ø1/8)
Installs into the tool's spindle for holding a rotary tool bit in place. Your tool
comes with one Ø1/8"collet. The shank diameter of the rotary tool bit must
match the size of the collet.
2 2-in-1 Wrench
• Use the front of the wrench for loosening/tightening the collet nut to
remove/install rotary tool bits or to change collets.
• Use the back of the wrench for adjusting the screw on the Sanding Drum
Mandrel (see page 10).
3
Sanding Drum Mandrel
(Ø1/8")
A mandrel with a cylinder-shaped rubber tip for attaching sanding bands.
Can be expanded or retracted using the back of the Wrench (see page 10).
4 Sanding Band
Slides over the top of the sanding drum mandrel to sand and smooth
around surfaces and inside curves.
NOTE: Replace the sanding bands when the grits are worn down.
5
Nylon Wire Brush
(Ø1/8")
For general cleaning and polishing purposes.
NOTE: Excessive pressure can damage the wires. Operate with light pres-
sure and let the tips of the wire brush do the work.
6
HSS Cutter Bit
(Ø1/8")
Use for edge cutting, carving and creating slots and holes in plastics,
wood and metals.
7
Grinding Stone Bit
(Ø1/8")
Use for various grinding applications including sharpening blades and
tools, removing flash from metal castings, deburring metal after cutting,
smoothing welded joints, grinding off rivets and removing rust.
8
Diamond Coated Bit
(Ø1/8")
For cutting and engraving in wood, plastics, and soft metals such as alu-
minum, copper, and brass.
Compatible Rotary Tool Accessories Kits: 150-Piece (Model 230151A), 282-Piece (Model 230282A),
320-Piece (Model 230321A), 327-Piece (Model 230327A), available for purchase at wenproducts.com.
9
To Next Page
Loading...
Need help?
General
