Why is my Wen 2312 Power Tool overheating?
Your Wen Power Tool may be overheating because you are forcing it to work too hard. Allow the tool to work at its own rate. Also, check if the attachment is dull or damaged and keep cutting accessories sharp, replacing them as needed. Another possible cause is blocked motor housing vents, so blow dust out of the motor using compressed air.
What to do if Wen 2312 will not start?
If your Wen Power Tool won't start, first check that the power cord is properly plugged in and that there is power at the outlet. If the outlet is unpowered, turn off the tool and check the circuit breaker. Internal damage or wear (like to the carbon brush or switch) may also be the cause, in which case you should have a technician service the tool.
Why does my Wen Power Tool performance decrease over time?
The performance of your Wen Power Tool may decrease over time if the attachment is dull or damaged; keep cutting accessories sharp and replace them as needed. Another cause could be worn or damaged carbon brushes, which should be replaced by a technician.
What to do if Wen Power Tool attachment is loose?
If the attachment on your Wen Power Tool is loose, first ensure that the holes on the attachment line up with the pins on the spindle. Remove the attachment and remount it, making sure the holes are secured over the pins. Also, check that the screw (Part# 1) is tightened to at least 100 inch-lbs.
Why does my Wen 2312 Power Tool operate slowly?
If your Wen Power Tool operates slowly, the extension cord might be too long or the wire size too small. Try eliminating the use of an extension cord. If an extension cord is necessary, use a shorter/heavier gauge cord. Refer to the ELECTRICAL INFORMATION section for more details.
What causes excessive noise from Wen 2312 Power Tool?
Excessive noise or rattling from your Wen Power Tool can be caused by internal damage or wear. In this case, have a technician service the tool.
What to do if my Wen 2312 will not start?
If your Wen Power Tool doesn't start, first, ensure the power cord is properly plugged in. Then, check if the outlet has power. If the outlet works, the issue might be internal damage or wear (like carbon brush or switch problems), and you should have a technician service the tool. If the outlet is unpowered, turn off the tool and check the circuit breaker.
What to do if my Wen Power Tool attachment is loose?
If an attachment is loose on your Wen Power Tool, first ensure that the holes on the attachment are aligned with the pins on the spindle. Remove the attachment and remount it, making sure the holes are secured over the pins. Also, check the screw (Part# 1) and tighten it to at least 100 inch-lbs.
Why is my Wen 2312 making excessive noise?
Excessive noise or rattling in your Wen Power Tool indicates internal damage or wear. Have a technician service the tool.
Details the limited one-year warranty for WEN consumer power tools for home use.
General| Brand | Wen |
|---|---|
| Model | 2312 |
| Category | Power Tool |
| Language | English |
To Next Page
