11
MAINTENANCE
Procedures not specifically explained in this manual must be performed only by a
qualified technician.
Warning: To Prevent Serious Injury From Accidental Operation:
Turn the power switch of the tool to its “OFF” position and unplug the tool from
its electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
To prevent serious injury from tool failure:
1. Before each use, inspect the general condition of the tool. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts, damaged electrical
wiring, and any other condition that may affect its safe operation. The sanding paper
should not be dull or contain excessive debris build-up. The scraper blade and saw
Blade should be clean and sharp.
2. After Use, clean external surfaces of the tool with clean cloth.
Warning: If the power cord of this tool is damaged, it must be replaced only by
a qualified service technician.
To Next Page
Loading...
Need help?
General
