8
CLEANING AND INSPECTION
1. Regularly clean dust, chips and other particles from the machine. If operation is excessively dusty or dirty, fre-
quent inspection of motor is required. Vacuum any particles that may have entered the motor.
2. Inspect the machine for any damaged or worn parts. Replace any damaged parts immediately for safe and effi-
cient operation. Frequently check that all nuts, bolts, screws have not loosened due to vibration.
3. Regularly check and empty the collection bag. Always wear respirator and safety glasses when removing, emptying
or replacing collection bags. Empty dust away from ignition sources and into a suitable container.
STORAGE
Store the unit and accessories in a dark, dry, frost-free and well ventilated place, out of the reach of children. The
ideal storage temperature is between 50 to 86 °F (10 and 30 °C).
PRODUCT DISPOSAL
Used power tools contain recyclable materials and should not be disposed with household waste. Please take this
product to your local recycling facility for responsible disposal and to minimize its environmental impact.
MAINTENANCE
WARNING: Always ensure that the tool is switched off and the plug is removed from the outlet before
making any adjustments or maintenance procedures.
OPERATION
WARNING: This dust collector is intended only for collecting wood dust and chips from woodwork-
ing machines. Do not use dust collector for anything except wood dust. Material such as liquids, aero-
sols, metal dust, screws, glass, plastic or rock can cause sparks when coming into contact with any part
of the collection system.
WARNING: Never allow steel to come into contact with impeller. Impact with any hard material may
result in sparks which may cause fire. Be mindful of any situation that results in a risk of fire.
1. Connect the dust collector to your woodworking machine using a 4-inch dust collection hose.
NOTE: Your dust collector is compatible with the WEN 28200 10 ft. dust hose and the WEN 28221 20 ft. dust
hose, available at wenproducts.com. Adaptors may be needed depending the dust port size of your woodworking
machine.
2. Make sure the dust collector switch is turned off and insert the power plug into a matching receptacle.
3. Switch on the dust collector and start operating your woodworking machine. Do not place your hands, lumber
or tools near the inlet opening while machine is plugged in or during operation. Keep animals and children away
from open dust collection inlets.
To Next Page
Loading...
Need help?
General
