16
MAINTENANCE
WARNING: In order to avoid personal injury and the risk of fire and electric shock, remove the battery pack
before adjusting, inspecting, or cleaning the chainsaw.
CLEANING
1. Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Keep the air vents free of
obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the air vents in water.
2. Wipe off the housing and the plastic components using a moist, soft cloth. Do not use strong solvents or deter-
gents on the plastic housing or plastic components. Certain household cleaners may cause damage, and may cause
a shock hazard.
3. Routinely clean out the dust and debris that gathers under the tension housing, the oil outlet, and around the
bar and the chain sprocket. Otherwise it can jam up the sprocket, the chain, and the lubrication system.
BATTERY
1. Make sure the battery is fully charged before storage in order to maximize the life of the battery.
2. Do not store the battery pack on the tool.
3. After charging, the battery pack may be stored in the charger, as long as the charger is not plugged in.
CHARGER
1. Keep the charger clean and clear of debris. Do not allow foreign material to get into the recessed cavity or onto
the contacts. Wipe the charger clean with a dry cloth. Do not use solvents or water, and do not place the charger
in wet conditions.
2. Unplug the charger when there is no battery in it.
3. Fully charge the battery before placing it in storage.
4. Store the charger at normal room temperature. Do not store it in excessive heat. Do not use the charger in
direct sunlight or in damp conditions. Do not charge outside. Recharge at room temperature. If the battery is hot,
allow it to cool down before recharging.
To Next Page
Loading...
Need help?
General
