9
UNPACKING & PACKING LIST
UNPACKING
With the help of a friend or trustworthy foe, carefully remove the Drill Press from the packaging. Make sure to take
out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list
below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact our
customer service at 1-800-232-1195 (M-F 8-5 CST), or email techsupport@wenproducts.com.
PACKING LIST
ASSEMBLY / ADJUSTMENT TOOLS
The tools listed below are not included but are required for either assembly or adjustment:
• Adjustable wrench
• Hammer and block of wood or rubber mallet, or dead-blow hammer
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
1
2
3
4
5
6
7
8
9 10
Head / Motor Assembly....................................1
Table Locking Handle.......................................1
Table Asssembly...............................................1
Base.............................................................1
Column Assembly............................................1
Chuck...........................................................1
Chuck Key........................................................1
Feed Handles...................................................3
Hex Wrench.....................................................1
Hex Head Bolts................................................3
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
To Next Page
Loading...
Need help?
General
