Last Updated: 10/27/2021
WEN 4214T Motor Replacement Guide
This a guide for replacing the motor on a WEN 4214/4214T drill press. If at any point you need
assistance, have questions, or want to order parts, call WEN customer service at 1-800-232-1195,
M-F, 8-5 Central Time, or email techsupport@wenproducts.com.
If replacing any parts, use only genuine replacement parts purchased from WEN Products.
Use of replacement parts not sold by WEN Products will void the product’s warranty and
could lead to decreased performance or injury.
TOOLS NEEDED
• Phillips-head screwdriver
• Circlip pliers
• Needle-nosed pliers
• #3 metric hex wrench
• 13mm wrench
• Adjustable head wrench
• Rubber mallet
• Level
PREPARING THE DRILL PRESS
1. To prepare the drill press for the motor removal procedure, turn the drill press on and
adjust it to maximum speed. Turn off the unit and unplug it from the power source. At
the pulley’s maximum speed setting, it will be easier to remove the belt and the motor
pulley assembly.
ENSURE THAT THE DRILL PRESS IS TURNED OFF AND UNPLUGGED FROM THE
POWER SOURCE BEFORE BEGINNING ANY MAINTENANCE OR REPAIR. FOLLOW
ALL SAFETY PROCEDURES LISTED IN YOUR OWNER’S MANUAL. USE COMMON
SENSE. AVOID INJURY.
REMOVING THE MOTOR PULLEY ASSEMBLY
1. Open the drill press lid by removing the screw circled in yellow in Figure 1.
To Next Page
Need help?
General
