7
KNOW YOUR SANDER
OPERATING INSTRUCTIONS
TOOL SET UP
WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug from
the power source outlet before making any adjustments.
1. Before installing sandpaper, make sure the hook and loop fastener base is free of dust and dirt and that the
sander is unplugged with the ON/OFF switch in the off “O” position.
2. The hook and loop fastener base will hold any hook and loop sandpaper without clamps or glue. Simply line
up the sandpaper with the hook and loop fastener base and press together, making sure front edge of the sandpa-
per is aligned with the front edge of the hook and loop fastener base.
3. To remove used sandpaper, peel one edge away from the hook and loop fastener base until the whole sheet is
free.
CAUTION: Do not use torn or severely worn or damaged sandpaper. To do so could damage the surface of the
hook and loop fastener base.
ON/OFF Switch
Vacuum Adapter
Detail Sanding Base
To Next Page
Loading...
