OPERATION
TOOL SET UP
1. Before installing sandpaper, make sure the hook and loop base of the sander is free of dust and dirt and that the
sander is unplugged with the ON/OFF switch in the OFF (O) position.
2. The hook and loop base of the sander will hold any hook and loop sandpaper without clamps or glue. Simply line
up the sandpaper with the sander base and press together, making sure the front edge of the sandpaper is aligned
with the front edge of the hook and loop fastener base.
3. To remove used sandpaper, peel one edge away from the base of the sander until the whole sheet is free.
WARNING! To avoid injury from accidental startups, turn switch OFF and remove the plug from the power
source outlet before making any adjustments or when you are finished using the tool.
CAUTION! Do not use torn or severely worn or damaged sandpaper. To do so could damage the surface of
the hook and loop base of the sander.
WORKPIECE AND WORK AREA SET UP
1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent
distraction and injury. We know your cat is super cute, but pay attention to your project.
2. Align the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the
power cord to possible damage. The power cord must reach the work area with enough extra length to allow free
movement while working.
3. Secure loose workpieces using vises or clamps (not included) to prevent movement while working.
4. Move all objects that could pose as a possible hazard away from the work area.
GENERAL OPERATING INSTRUCTIONS
1. Make sure that the power switch is in the OFF position, then plug in the tool.
2. Turn the switch to the ON position “I”.
3. Do not use excess pressure while sanding. Always sand in same direction as the grain of the wood. Let the sand-
paper do the work. Apply even pressure over the entire workpiece.
4. Check the wear on the sandpaper at regular intervals and replace as necessary.
NOTE: Always turn the switch OFF and unplug the sander before changing sheets of sandpaper.
5. When sanding is competed, remove the sander from the workpiece and turn the power switch to the OFF position
“O”.
6. When completely finished using the sander, use a vacuum to dislodge all sand shavings and dust from the
vacuum port. Wipe the sander clean with a soft cloth.
7. To prevent accidents, turn off the sander and unplug it after use. Clean, then store the sander indoors out of
children’s reach.
9
To Next Page
Loading...
Need help?
General
