DRAINING/CHANGING OIL
Change the oil according to the Recommended Maintenance Schedule in Table 4.
Change the oil MORE OFTEN if operating under heavy load or high ambient temperatures. It is also necessary to
drain the oil from the crankcase if it has become contaminated with water or dirt. Changing the oil when the engine
is warm allows for complete drainage.
1. Close the gas cap and vacuum relief valve.
2. Place generator on elevated platform such as table or workbench Prepare a gasoline-approved container to catch
the oil as it drains.
NOTE: To avoid possible oil spills from the carburetor bowl, drain the carburetor before draining oil.
3. Using a coin, turn the oil access cover screw 1/4 turn clockwise, then remove the access cover from the service
panel. Remove the dipstick and tilt the generator towards you and allow the oil to drain from the engine completely.
NOTE: Never dispose of used motor oil in the trash or down a drain. Please call a local recycling center or auto
garage to arrange proper oil disposal.
4. Using a funnel or appropriate dispenser, add 11.8 oz of clean engine oil until you can see oil coming up the
threads of the oil fill. Do not over fill.
5. Reinstall the oil dipstick and tighten it securely. Wipe clean any oil spillage and reinstall the oil access cover.
MAINTENANCE
33
To Next Page
Loading...
Need help?
General
