2120
STARTING THE GENERATOR (LPG)
1. Turn the fuel valve (Fig. 14 - 1) to the OFF position.
2. Connect the LPG regulator hose assembly to the inlet on
the generator. Turn the LPG tank valve ON.
3. Pull the choke button out to the CLOSED/START position
(Fig. 15).
4. Prime the engine by gently pulling the recoil starter 1 - 3
times.
5. Flip the engine switch (page 12) to the RUN position.
6. Pull on the recoil starter handle (page 11) slowly until a
slight resistance is felt, then pull quickly to start the engine.
Return cord gently into the recoil starter. Never allow the
cord to snap back.
7. If engine fails to start, repeat this step.
8. Once the engine has started, slowly push the choke but-
ton in to the OPEN/RUN position (Fig. 15).
NOTE: If the engine is warm, you may need to adjust the
position of the choke button.
9. Allow the engine to run for several minutes before at-
tempting to connect any electrical devices. This allows the
generator to stabilize its speed and temperature. Follow
the instructions in the next section for properly connecting
your electrical devices.
STARTING YOUR GENERATOR
Fig. 14
Fig. 15
1
ON
OFF
To Next Page
Loading...
