INSTRUCTION MANUAL
KNOW YOUR PEN PRESS
MODEL LA3040
PEN PRESS
THANKS FOR
REMEMBERING
V. 2019.09.16
ASSEMBLING YOUR PEN PRESS
1. Affix the handle to the toggle clamp and secure with
the included screw. (Fig. 1)
2. The pen press comes with mounting holes. This
enables the pen press to be mounted onto a work
surface for secure pressing. To do so, insert six M6
flathead screws (not included) into the mounting
holes. (Fig. 2)
Fig. 1
1
2
3
4
5
7
Fig. 2
1. Adjustment Knob
2. Tip-End Rod
3. Press Cylinder
4. Base
5. Rubber Grip
6. Handle
7. Toggle Clamp
6. Flathead Screw
INCLUDED
FLATHEAD SCREW
6
8
NOTE: The pen press does not need to be mounted and can be used simply by holding the base with
one hand.
To Next Page
Need help?
General
