ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing
materials until assembly is completed. TOOLS REQUIRED FOR ASSEMBLY: An adjustable
wrench _ (not Included).
1,
Raise the Left Upright (not shown) and Right Upright (21)
to the vertical position. Insert an Upright Bolt (37) with an
Upright Washer (39) through the plate on the lower end of
the Right Upright (21) and tighten the Bolt into the Frame
(46). Tighten the Upright Bolt that is already in the plate.
Make sure the Upright Caps (73) are on the Left and Right
Uprights.
2. Insert an Upright Bolt (37) with an Upright Washer (39)
through the plate on the lower end of the Left Upright (75)
and tighten the Bolt into the Frame (46). Tighten the
Upright Bolt that is already in the plate.
3. Remove the paper backing from the Wrench Clip (61).
Press the Wrench Clip onto the Right Endcap (57) in the
indicated location. Press the Allen Wrench (59) into the
Wrench Clip.
Make sure that all parts are tightened before using the tread-
mill. Note: To protect the floor, a covering should be
placed under the treadmill.
6
To Next Page
Loading...
Need help?
General