10
6. Attach the Storage Latch (58) to the Left Upright
(57) with two #10 x 1" Tek Screws (4); start
both Tek Screws, and then tighten them.
6
4
57
58
7. The incline of the treadmill can adjusted to two
different levels. Rotating the Right and Left
Incline Feet (41, 42) to the position shown will
position the Frame (40) at the lower incline level.
7
41
42
40
8. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight.
Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see
page 18). Note: Extra parts may be included.
To Next Page
Loading...
Need help?
General