What to do if my Weslo Treadmill power turns off during use?
If the Weslo Treadmill power turns off during use, try the following: 1. Check the power switch. If it has tripped, wait five minutes, then press it back in. 2. Ensure the power cord is securely plugged in. 3. Remove and reinsert the key into the console. 4. If the treadmill still won't run, please see the front cover of this manual.
How to fix a Weslo Candence 16.0 Treadmill that the power does not turn on?
To troubleshoot a Weslo Treadmill that won't turn on: * Ensure the power cord is plugged into a properly earthed outlet. If using an extension cord, it should be a 3-conductor, 14-gauge (1 mm[2]) cord no longer than 5 ft. (1.5 m). * Verify that the key is inserted into the console after plugging in the power cord. * Check the power switch on the treadmill frame near the power cord. If it's protruding, the switch has tripped. To reset it, wait five minutes and then press it back in.
Why does my Weslo Candence 16.0 walking belt slows when walked on?
If the walking belt on your Weslo Treadmill slows down when you walk on it: * Ensure that if you're using an extension cord, it's a 3-conductor, 14-gauge (1 mm[2]) cord that is no longer than 5 ft. (1.5 m). * If the walking belt is too tight, it can decrease performance and damage the belt. Remove the key and unplug the power cord. Use the hex key to turn both idler roller bolts counterclockwise, 1/4 of a turn. When properly tightened, you should be able to lift each edge of the belt 2 to 3 inches off the platform. Keep the belt centered. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the belt is properly tightened. * If the walking belt still slows when walked on, see the front cover of this manual.
Why console displays remain lit when I remove the key from Weslo Candence 16.0 Treadmill console?
If the console displays on your Weslo Treadmill remain lit after removing the key, the console is in display demo mode. This mode is designed for when the treadmill is displayed in a store. To turn off demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 14 to turn off the demo mode.
What to do if Weslo Treadmill walking belt is off-center or slips when walked on?
If the walking belt on your Weslo Treadmill is off-center or slips when you walk on it, here's what you can do: * If the belt has shifted to the left, remove the key and unplug the power cord. Use the hex key to turn the left idler roller bolt clockwise 1/2 of a turn, being careful not to overtighten the belt. If the belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 of a turn. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the belt is centered. * If the belt slips when walked on, first remove the key and unplug the power cord. Using the hex key, turn both idler roller bolts clockwise, 1/4 of a turn. The walking belt should be tightened correctly, so you are able to lift each edge of the walking belt...
General| Speed | 0-10 mph |
|---|---|
| Speed Range | 0-10 MPH |
| Display | LCD |
| Running Area | 16 x 50 in |
| Weight Capacity | 250 lbs |
| Folding | SpaceSaver Design |
To Next Page
