11
9
65
90
74
13
11
10
12
10
78
86
88
18
18
70
58
89
9. Identify the Right Upper Arm (13) and orient it as
shown. Then, slide the Right Upper Arm onto the
Right Lower Arm (11).
Attach the Right Upper Arm (13) with two
M8 x 16mm Screws (74), two M8 Split Washers
(90), and two M8 Curved Washers (65); start
both Screws, and then tighten them.
Attach the Left Upper Arm (12) to the Left
Lower Arm (10) in the same way.
10. Identify the Right 1/2" x 110mm Bolt (70) and the
Right 1/2 " Nut (85). Apply grease to the Right
Bolt.
Attach the Right Arm Bracket (88) to the
right side of the Crank (18) with the Right
1/2 " x 110mm Bolt (70), an M13 Wave
Washer (58), an M13 Washer (69), and the Right
1/2 " Nut (85); firmly tighten the Right Nut
clockwise.
Repeat this procedure to attach the Left Arm
Bracket (89) with the Left 1/2 " x 110mm Bolt
(78), an M13 Wave Washer (not shown), an
M13 Washer (not shown), and the Left 1/2 "
Nut (86). IMPORTANT: You must firmly tighten
the Left Nut counterclockwise to attach it.
See assembly steps 5 and 6. Tighten the four
M8 Locknuts (84).
Grease
69
85
To Next Page
Loading...
Need help?
General
