9
6
5. Insert the excess wire and cable into the
Frame (1).
Tip: Avoid pinching the wires and the cables.
Slide the Upright (2) onto the Frame (1).
Attach the Upright (2) with two M8 x 65mm Bolts
(75), four M8 Curved Washers (65), two M8 Split
Washers (90), and two M8 Locknuts (84); do not
fully tighten the Locknuts yet.
5
Avoid pinching
the wires and
the cables
2
2
1
75
84
84
90
90
65
65
75
65
65
75
65
84
65
90
90
65
65
75
84
6. Finish attaching the Upright (2) with two
M8 x 65mm Bolts (75), four M8 Curved Washers
(65), two M8 Split Washers (90), and two
M8 Locknuts (84); do not fully tighten the
Locknuts yet.