Westcott Micro Apollo - Halo Setup and Usage

8 FJWESTCOTT.COM
Secure the light modifier by putting
the tip of the umbrella shaft into
the metal cup. Close the lower
hook and loop tape opening
around the light stand.
To mount the standard Halo light
modifier onto your light, open the
hook and loop tape opening
and open the frame.*
Halo
™
Setup UsagE
#2025, 2026 EACH CONTAIN: [1] Halo [1]
1 2 3
4 5
Place the light inside of the opening
of the Halo and insert the umbrella
shaft through the light’s umbrella
receptacle. Position the light
anywhere along the umbrella shaft

Tighten the setscrew against the
shaft. Do not over tighten! This
could damage the umbrella shaft.
After the Halo is securely in
place, carefully stretch the black
back section over the end of the
umbrella shaft. Over stretching
may cause damage to the fabric
or frame.
*Note: When using the #5015
Adjustable Shoe Mount Bracket,
attach your speedlite to the
bracket before assembling your
modifier.