9
panel will govern the brightness of the center of the light.
Caution: Do not over tighten! Overtightening may cause
damage to the umbrella shaft. See the first part of the
above paragraph to explain placement of the light along
the elastic collar on the back of the Halo Mono around
the front portion of the mono light. With the mono light
standard reflector in place, the flash tube and reflector
should be inside the Halo and the controls should be
outside. Finish mounting the Halo Mono by closing the
hook and loop tape opening creating a snug fit.
light, purchase an optional
Reflector Plate (#2875).
The anodized aluminum
plate is mounted on the
center shaft just in front of
the flash tube. This allows
reflector plate, into the silver
metallized material and then
Plate can be adjusted along the center shaft
closer or further from the flash tube to control
interior of the Halo.
©Terry White
©David Ziser
To Next Page
Loading...
