Westerbeke W-27 User Manual

STOPPING PROCEDURE
1. Stop
To stop the engine move the
throttle control through the
idle position to stop. As the
throttle is moved past idle
there will be increased
resistance to movement because
a spring loading must be over-
come. Hold the throttle firmly
against the pressure until the
engine comes to a complete
stop.
2. Starter switch off
Wi th the eng ine stopped, turn
the star ter key back to "OFF"
position. The battery will be
discharged if the key is left
at "ON" position. An engine
alarm buzzer is provided to
warn the operator of this
possibili ty. Best precaution
is always to remove the key.
W-13
CAUTIONS ON STARTING AND OPERATION
1. Normal starting
W21,27,33
Follow the procedures below for routine starting of your engine.
1) Check the engine and transmission oil levels and refill if
necessary.
2) Insure that you have sufficient fuel. Keep tank as full as
possible.
3) Check coo~ng water level, and refill if necessary.
Note: Check for leaks of water or oil, particularly when
signs of such leak are found on the bottom of the engine or
in the drip tray.
4) Start the engine in accordance with the procedures given on
the preceding pages.
5) Allow the engine to warm up to 140·-150· F before placing the
engine under heavy load.
2. Starting under cold conditions
The following three adverse condi tions concur as the atmospher ic
temper a-ture drops exceedingly, and the engine must, under such
conditions, be started by taking steps described below:
10

Westerbeke W-27 Specifications

General

Brand	Westerbeke
Model	W-27
Category	Engine
Language	English