WD SERIAL ATA RAID CONTROLLER
INSTALLING SOFTWARE DRIVERS - 18
USER MANUAL
Existing Windows 2000 Installation
After installing the WD SATA RAID Controller and rebooting your system, Windows 2000
setup will show a New Hardware Found dialog box.
1. Choose Add New Hardware Wizard from the list, and then press ENTER.
2. Choose Add/Troubleshoot a device and click Next. The new hardware wizard will show
device list
3. Choose Mass Storage controller and click Next. At the following screen click Finish.
4. Choose Display a list the known drivers for this device so that I can choose a specific
driver then click Next.
5. When the Windows 2000 supported SCSI adapter drivers list appears, click Have disk.
6. Insert the WD SATA RAID Controller diskette into the floppy disk drive.
7. Choose Win2000 WD SATA RAID Controller from the list that appears on screen, then
click Next.
8. Click Yes to confirm continue the installation and copy the driver to system.
9. Remove the diskette and click Finish to restart the system. Windows 2000 will then
restart for the driver installation to take effect.
Confirm Windows 2000 Driver Installation
1. Right-click on the My Computer icon and select Manage from the popup menu.
2. From the left panel, select Device Manager.
3. Click the + in front of SCSI controllers. Win2000 WD SATA RAID Controller should
appear.
To Next Page
Loading...