EasyManua.ls Logo

Westinghouse WHG952SB - User Manual

Westinghouse WHG952SB
11 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USER MANUAL
GAS COOKTOPS
WHG644SA, WHG646SA, WHG756SA,
WHG952SB, WHG956SA

Table of Contents

Questions and Answers

  • M
    Michele PierceAug 3, 2025
    Why won't my Westinghouse Cooktop burner light even though the sparker is working?
    • R
      Robert ThomasAug 3, 2025
      If your Westinghouse Cooktop burner won't light despite the sparker working, several factors could be at play. First, make sure you're holding the knob down long enough in the 'High' position to engage the flame safeguard. Try repeating the lighting procedure, holding the knob down for 5 seconds. Also, verify that the gas supply valve is turned on and that you're turning the correct knob for the burner you want to light. Check for any port blockages in the ignition area, ensuring they are clean and dry. Lastly, inspect the ignition spark plugs to ensure they are dry and clean.
  • T
    tonyaellisAug 9, 2025
    What to do if Westinghouse Cooktop flames not staying on when knob released?
    • S
      Sara MurrayAug 9, 2025
      If the flames on your Westinghouse Cooktop won't stay on after releasing the knob, it could be due to a few reasons. Ensure you are holding the knob down long enough in the ‘High’ position for the flame safeguard to engage. Try repeating the lighting procedure, holding the knob down for 5 seconds. Also, the knob MUST be set between ‘High’ and ‘Low’ positions. Finally, check the flame safeguard sensor for any dirt or spillage and clean the sensor tip if necessary.
  • C
    Cody HicksAug 16, 2025
    Why is there no spark when I turn the control knob on my Westinghouse Cooktop?
    • B
      brian06Aug 16, 2025
      If you're not getting a spark when you turn the control knob on your Westinghouse Cooktop, the electricity supply might be disconnected or switched off. Make sure to switch on the electricity or check the fuses. Another potential cause is wet or dirty ignition spark plugs; in this case, dry or clean the ignition spark plugs.
  • D
    dfullerAug 21, 2025
    Why are the benchtop or knobs on my Westinghouse WHG952SB overheating?
    • K
      Kevin ZhangAug 21, 2025
      If the benchtop or knobs on your Westinghouse Cooktop are overheating, it might be due to using the incorrect cooking pot or pan. Ensure the pot or pan is centrally located on the burner and that you are using the correct type.
  • N
    Nicholas MitchellAug 27, 2025
    How to fix uneven or lifting flames on a Westinghouse Cooktop?
    • M
      Ms. Linda WrightAug 27, 2025
      Uneven or lifting flames on your Westinghouse Cooktop can often be attributed to blocked or wet flame ports. Try cleaning or drying the flame ports. Another possible cause is that the burner is incorrectly fitted, so ensure this component is fitted correctly.

Summary

IMPORTANT SAFETY INSTRUCTIONS

Damage Reporting and Claims

Safety Warnings and Cautions

Essential safety warnings, cautions, and important usage tips.

Preventing Hazards

Advice on avoiding fires, burns, and misuse of the appliance.

INSTALLATION PROCEDURE

Installation Safety Precautions

Warnings and cautions for safe installation by authorized personnel.

TROUBLESHOOTING GUIDE

Ignition and Flame Issues

Solutions for burners not lighting, uneven flames, or pilot light issues.

INSTALLATION INSTRUCTIONS

Regulatory Compliance

Appliance must be installed by authorized person per local and national gas/electrical codes.

LPG Conversion Warning

INSTALLATION PROCEDURE DETAILS

Bench Cutout and Clearances

Requirements for bench cutout dimensions and clearances to combustible surfaces.

Securing and Sealing

Safety Warning: Gas Leak Risk

Critical warning about potential gas leaks if the cooktop is not properly fixed.

GAS CONNECTION AND OPERATION

Supply Pipe Sizing and Elbows

Regulator Function and Assembly

Details on the appliance regulator, its assembly, and operation.

LPG CONVERSION PROCEDURE

Injector and Regulator Conversion

Step-by-step guide to convert the appliance from Natural Gas to LPG.

ELECTRICAL CONNECTION

Power Supply Requirements

Details on the standard 7.5Amp service cord and its connection to a household socket.

TESTING APPLIANCE OPERATION

Initial Ignition and Flame Check

Procedures for testing ignition on all burners and observing flame appearance.

Turndown and Bypass Adjustment

ELECTROLUX WARRANTY TERMS

Warranty Coverage and Exclusions

Details on warranty period, acceptable quality, and situations not covered by the warranty.

Westinghouse WHG952SB Specifications

General IconGeneral
BrandWestinghouse
ModelWHG952SB
CategoryCooktop
TypeGas Cooktop
Fuel TypeGas
Number of Burners5
Surface MaterialStainless Steel
Cooktop MaterialStainless Steel
MaterialStainless Steel
Control TypeKnob
Ignition TypeElectronic
Gas TypeNatural Gas

Related product manuals