Westlock 9479 User Manual

WESTLOCK CONTROLS CORPORATION
280 MIDLAND AVENUE, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
5/05/12 TECH-461/D.W.O. 19909 Page 1 of 24
WIRELESS VALVE MONITORING SYSTEM
WIRELESS DEVICE
OPERATING MANUAL
Models: all models equipped with WD module, including but
not limited to 1100, 9468, 3500, 3449, 3049, 9479, 366, 711,
764, 765, 777, 877, 2004, 2007, 2200, 2600
IOM: Tech-461
Revision: 5
Prepared By: R. da Mata
Date: 03/2012
Drafting Work Order:
19909
ECN:
Reviewed By: xxxxx
Date: xxxxx
Approved By: xxxxx
Date: xxxxx
This IOM contains confidential information and is issued in confidence on the condition that it be returned on demand and not be copied,
reproduced, disclosed to others or used in manufacture of the subject matter thereof without the written consent of Westlock Controls

Westlock 9479 Specifications

General

Brand	Westlock
Model	9479
Category	Measuring Instruments
Language	English

Summary

Introduction to Westlock Wireless Valve Monitoring System

General Safety Warnings

Presents critical safety warnings and precautions for equipment handling and operation.

System Principles of Operation

Wireless Device (WD) Overview

Describes the WD, its function, power, sensors, and communication capabilities.

Wireless Device (WD) Operation and Specifications

Wireless Device Overview

Introduces the WD as the sensing component, detailing its mounting and function.

Wireless Device LEDs and Indicators

Explains the function of the 4 internal LEDs for diagnostic purposes.

WD Technical Specifications

Details technical specifications like wireless communication, range, latency, and measurement.

WD Installation Guide

Guides on mounting the WD on valves using appropriate brackets.

Powering Up and Shutting Down the WD

Details the procedure for powering up and shutting down the Wireless Device.

WD Configuration Process

Explains how WDs are configured using WMS or WH, detailing the information installed.

Setting Operational Parameters for WD

WD Calibration Procedure

Guides on calibrating the WD to set open/closed boundaries using the WH.

WD Troubleshooting and Maintenance

Device Does Not Power Up

Provides steps to diagnose and resolve issues with the WD not powering up.

Device Not Presented in WMS

Offers solutions for when the WD is not visible or recognized by the WMS.

Invalid Angle Readings from Device

Device Performs Continuous Resets (LEDs Flashing)

Faulty WD Calibration Results

WD Information Not Presented in HMI/PLC

Battery Replacement Procedure

Provides step-by-step instructions for replacing the WD battery pack.