5 . U S E O F PA Y ME N T S Y S T E MS M DB
The coin mechanism must be connected and disconnected with
the machine turned off. Connect payment system, and switch on
machine - enter programming and set Command 69 and program
to value 5. Then switch off the machine for approx 30 seconds.
Switch on again and the payment system will communicate.
Command 27: Setting the signal for payment system out of
order
If the command is set at 1 - when connection is interrupted - the
machine goes out of order and message appears on the display to
alert of this. If the command is set at 0 - the option is disabled.
Command 28: Select change giving tube content counter
This command allows the user to select whether to use the
counters corresponding to the content of the coin mech change
giving tube or the counters inside the machine. If command set to
1 - at each power-up the counters insode the machine areupdated
with the values transmitted by the coin mechanism. If command is
set at 0 - the values transmitted are ignored.
Command 29: Cashless credit cannot be displayed
Command allows user to prevent or enable display of credit from
the MDB cashless device /card reader. If command is set to 1 - the
credit corresponding to the cashless device is not displayed. If
command is set to 0 - machine displays the credit available on the
cashless device.
18. Setting Payment Systems
To Next Page
Loading...
