Command 80: Cloning
This command makes it possible to transfer all parameters of the
machine to a "USB" so other machines can be set up to the same
specification. DO NOT enter the USB stick before entering the
programming mode. when you enter the command "Write Clone
Key" appears on the display - then enter the USB stick and press
ENTER.
Command 90: Select AUDIT protocol
Through this command it is possible to choose the mode of data
sent to the jack RS232. There are 3 levels:
LEVEL 1 - Totals regarding the transactions.
LEVEL 2 - Totals regarding the transactions of level 1; plus sales
per each selection.
LEVEL 3 - Totals regarding the transactions in level 1; data
regarding the last 5 power on/off; data regarding the error
events.
Command 92: Clear Sales Data
Used to clear the machine's sales data. A special access code
must be entered for this operation. When you enter Command
92, Code 0000 appears on the display, Type 1221 and press
ENTER, "Clear Data?" appears on the display. Press ENTER to
clear all the sales data / ESC to return to main menu without
saving changes.
Command 93: Displaying Temp pattern for the last 24 hours
The values are recorded at 15 min intervals, starting with furthest
back in time. After clock programming - all data are reset.
19. Command Codes EXPLANED
To Next Page
Loading...
