Note:
The way of inquire of the last error code shows at the chapter 9.7 the Last
Fault inquiring.
If the fault appears, user can reset the fault using 3 methods showing below.
Press key and maintain 3 seconds.
Connect controlled terminals RET and COM, and maintain 3 seconds.
Shut down the power and power on again.
Note:
The way of inquire of the last error code shows at the chapter 9.7 the Last
Fault inquiring.
If the fault appears, user can reset the fault using 3 methods showing below.
Connect controlled terminals RET and COM, and maintain 3 seconds.
Shut down the power and power on again.
12.2 Overload protection and protection level12.2 Overload protection and protection level
Overload protection function is worked during the process of starting and
running.
Overload protection function is worked during the process of starting and
running.
There are 8 protection levels. The default is 4(same as 15 in
IEC60974-4-2 standard). User can set this parameter according to the
load situation, the smaller this parameter is, the shorter the starting
time of protection is, vice verse.
There are 8 protection levels. The default is 4(same as 15 in
IEC60974-4-2 standard). User can set this parameter according to the
load situation, the smaller this parameter is, the shorter the starting
time of protection is, vice verse.
The level 2 can't be selected ( same as 10A in IEC60974-4-2 standard).
For detail see the table 12-2 and standard curve graph of IEC60974-4-2.
The level 2 can't be selected ( same as 10A in IEC60974-4-2 standard).
For detail see the table 12-2 and standard curve graph of IEC60974-4-2.
Motor Thermal Protect Curve
T(s)
10000
1000
100
10
1
0.5
1.12 1.5 2.00 2.50 3.00 3.50 4.00 4.50 5.00 5.50 6.00 6.50 7.00 7.50 8.00
2
10A
10
15
20
25
30
I/Ie
User ManualUser Manual User ManualUser Manual
30
OPERATION
MENU
31
OPERATION
MENU
2
Table 12-1
MultipleMultiple
LevelLevel
StandardStandard
Special
To Next Page
Loading...
Need help?
General
