Hydraulic Quick Lift
Service Jacks
Operating Instructions and Parts Manual 13X032A and 13X037A
SHI844
Printed in China
082015
Please read and save these instructions. Read through this owner’s manual carefully before using product. Protect yourself
and others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in
personal injury and/or damage to product or property. Please retain instructions for future reference.
Description
Westward Hydraulic Quick Lift Service Jack is a self contained device for lifting, but not sustaining, a partial vehicle
load. Service jacks (13X032A and 13X037A) with Quick Lift System provide one pump to lift point contact. This jack is
equipped with a built-in by-pass device to prevent damage from over loading.
Specications and Dimensions
General Safety Information
Save these instructions. For your safety, read, understand, and follow the information provided with and on this device
before using. The owner and/or operator shall have an understanding of the device, its operating characteristics and
safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use and
repair of this product may require special skills and knowledge. Instructions and safety information shall be read to
and discussed with the operator in the operator’s native language, making sure that the operator comprehends their
contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this device,
remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing parts
are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall be
removed from service until repaired. If the equipment has been or is suspected to have been subjected to an abnormal
load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact distributor or
manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be made by an authorized
repair facility. Labels and Operator’s Manuals are available from the manufacturer.
Oil Filler Vent Screw
(reference parts illustration for location)
Handle
(release valve)
Saddle
Lifting Arm
Caster
Front Wheel
Handle Fork
Figure 1 - Typical Jack Nomenclature
Model Capacity Length Handle Length
Min Saddle Height Max Saddle Height
13X032A 3-1/2 Ton (3,175 kg) 30-7/8" (78.42 cm) 49-7/8" (126.68 cm) 4" (10.16 cm) 21-5/8" (54.93 cm)
13X037A 2-1/2 Ton (2,268 kg) 29-3/8" (74.61 cm) 49-7/8" (126.68 cm) 4" (10.16 cm) 20-1/4" (51.44 cm)
To Next Page
Need help?
General
