push
MODE
Depth mode and saving of swimming shelf
At rst time turning power on of the reel, it is arranged at its depth mode.
The display shows the depth (released length of f ishing line) in big numerals (1).
Now you can save the of quantity of released line (depth), on where you want to
offer the bait. This can be the ground or even the depth where you get your
last bite of a sh.
(1) Release line until the bait is on the required depth.
The main display shows the actual depth.
When the required depth is reached,
push the “MODE“ button once.
Now this depth is saved as “swimming shelf“ and is
shown with smaller numerals below the main display.
When you descend your bait at next time, 5 meters before reaching the saved “swimming shelf“
any meter will be signalized acousticly by short beeps. A long beep signalizes the reaching
of the saved “swimming shelf“.
You can reprogram a new “swimmimg shelf“ at any time
by repeating the discribed steps upon.
* it´s not possible to program a “swimmimg shelf“ less than 10 meter.
* it´s not possible to save a “swimmimg shelf“ while operating with the electric motor.
16
To Next Page
Loading...
