Wheelock POWERPATH PS-12-24-8 User Manual

P83862 M Sheet 14 of 23
Example 5: IN>OUT SYNC MODE with External Sync Module with Audible Silence (CLASS B)
POWERPATH
1
2 3
4
ON
OUT1-4
INPUT SELECT
TEMPORAL
STROBE SYNC
IN>OUT SYNC
LOGIC BOARD
SWI "OPEN"
SW2 "OPEN"
TO NEXT
APPLIANCE
OR EOLR
-
+
IN1
-
+
RET1
+ OUT1
+ IN1
MINUS 1
+ AUDIBLE
SM/DSM
F
A
C
P
EOLR
- AUDIBLE
EOLR
2.2K OHMS
EOLR
2.2K OHMS
+
OUT4
-
+
OUT3
-
EOLR
2.2K OHMS
-
+
OUT2
+
-
OUT1
OR EOLR
(2.2K OHMS)
TO NEXT APPLIANCE
NOTE: When using the Wheelock external Sync Module (SM or DSM), synchronization will only occur
with Wheelock sync
appliances.
Example 6: WHEELOCK SYNC MODE without Audible Silence (CLASS B)
POWERPATH
1
2 3
4
ON
OUT1-4
INPUT SELECT
TEMPORAL
STROBE SYNC
IN>OUT SYNC
LOGIC BOARD
SWI "OPEN"
SW2 "OPEN"
IN1
+
-
IN2
+
-
TO NEXT APPLIANCE
OR EOLR
+
RET2
-
P
C
A
F
RET1
+
-
-
OUT4
-
+
OUT3
+
OUT2
-
+
EOLR
2.2K OHMS
EOLR
2.2K OHMS
EOLR
2.2K OHMS
+
-
OUT1
TO NEXT APPLIANCE
OR EOLR
(2.2K OHMS)
• This mode will only synchronize Wheelock horns, horn strobes, and strobes with the synchronization capability.
• If only strobes are connected to the POWERPATH outputs, the initiating input to IN2 is not required.
• When synchronized horns are used on the two wire output of the POWERPATH, IN2 must be connected as shown or the
horns will not operate.

Wheelock POWERPATH PS-12-24-8 Specifications

General

Brand	Wheelock
Model	POWERPATH PS-12-24-8
Category	Power Supply
Language	English