Grab the handle near the center of the front-drive base while tilting up the rear-drive base. Then align Bar B with
the hook on the rear-drive base.
Slowly tilt the rear-drive base forward and connect it to the front-drive base. The base release handle of the rear-
drive base latches onto Bar A of the front-drive base. A click will be heard when the two parts are connected
properly.
Installing the storage basket
Align the hooks on the bottom of the storage basket with the frame of the front-drive base, then push the storage
basket straight down. Push the flat part at the bottom of the basket until it clicks.
If the device does not start properly even though a charged battery is inserted to the device and the
device is turned on, remove the battery, then re-insert the battery after 10 seconds.
Installing the seat assembly
To Next Page
