Whirlpool ADG-934 - Page 4

1. Switch off the dishwasher and turn off the
water tap at the end of the programme.
2. Before carrying out any cleaning or
maintenance, unplug the appliance and turn
the tap off.
3. If there is a fault, unplug the appliance and
turn the tap off.
4. Do not allow children to play with or in the
dishwasher.
5. The opened door can only take the weight
of the pulled-out rack, including crockery. Do
not use it as a working surface and do not
stand or sit on it: the appliance could topple
over!
6. If a power cable is damaged replace it with
an identical one. Contact the After-Sales
Service; it must only be replaced by a
qualified: technician.
7. Valid only for appliances with water-stop
system: there are electrical parts in the inlet
hose and the plastic casing of the water
connection.
Therefore the hose should not be cut and
the plastic casing should not be immersed in
water.
If the hose is damaged, immediately pull the
plug out of the socket.
8. Do not put any solvent in the dishwasher
compartment; there is a danger of explosion!
1. Packaging materials (plastic bags, polystyrene
parts, etc.) must be kept out of children’s
reach since they are potentially dangerous.
2. The packaging box is recyclable and is
marked with the recycling symbol &3.
3. Make sure that the dishwasher has not been
damaged during transport and that the door
closes tightly.
4. Only use the dishwasher for household
purposes.
5. Make sure that the installation and the
electrical connection are carried out by a
qualified technician according to the
Manufacturer's instructions (please refer to
the separate installation instructions) and in
compliance with local standards in force.
6. The dishwasher is made with reusable
material. When scrapping, follow the local
disposal regulations and make it unusable by
cutting the power cable off.
Please follow the separate installation instruc-
tions!
Electrical connection
1. Please follow the standards in force specified
by the local Electricity Board.
2. Make sure that the voltage indicated on the
rating plate corresponds to the voltage in
your home.
Water inlet and outlet
1. Please follow the standards in force specified
by the local Water Board.
2. Make sure that the water inlet and outlet
hoses are kink-free.
3. If the hoses are not long enough, please
contact the After-Sales Service or your
Retailer.
4. The inlet hose must be firmly and tightly
screwed on to the tap.
5. The dishwasher can be connected to cold or
hot water up to 60 °C.
6. When installing the appliance make sure that
the drained water flows away freely (if
eel remove the wire gauze from the
trap).
7. The outlet hose must be fastened to the trap
with a clamp to prevent it from falling.
8. Valid only for appliances with water-stop .
system:
If the water connection instructions are
complied with, the water stop system
basins your home against damage caused
y water leaks.
1. Unplug the appliance.
2. Turn the tap off.
3. Detach the inlet and outlet hoses.
4. Drain any remaining water from the
dishwasher and the hoses.
5. Transport the dishwasher in the upright
position.