Whirlpool ADG-934 - Page 8

Rinse-aid is necessary so that no water spots, streaks
or stripes remain on the crockery after washing. The
dispenser must be filled before using the dishwasher,
The level must then be checked regularly.
Only use rinse-aid for dishwashers.
1. Open the dispenser, press button A.
2. Fill with rinse-aid up to the mark.
3. Immediately wipe up any spilt rinse-aid to
avoid the formation of excess foam which will
spoil washing results.
4. Close the dispenser.
Setting the rinse-aid dispenser.
(Open and then close the cover after having added
the rinse aid).
Setting for a new dishwasher: 3.
If you are not satisfied with washing or drying results,
change the setting (use a coin or a spoon handle).
Water spots on crockery: set on a lower position.
Damp crockery: set on a higher position.
Low rinse-aid indicator
The dishwasher is equipped with a visual and an
electric indicator.
Visual indicator:
(*) bright = add rinse-aid!
@ dark = there is enough rinse-aid
Electric indicator:
the 3 indicator lamp on the control panel comes on
when rinse-aid must be added.
23