Whirlpool ADP 5600 - User Manual

GB
-1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarely paused: the
Start indicator blinking. To restart the cycle close
the door and push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher (1
minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
(see at right for options description)
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Table of programs
Deter-
gent
Consumption
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Delay Crockery to be washed later. — 5.0 0.02 10
2
Glasses 40°C
Delay
Light soiling, for example glasses
and cups.
X 13.0 0.90 97
3
Quickwash 40°C
Delay
Lightly soiled crockery, with no
dried-on food.
X 13.0 0.70 30
4
Eco
2)
50°C
Delay
Half load
Normally soiled crockery. X 15.0 1.05 150
5
Intensive 70°C
Delay
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X 15.0 1.50 140
5019 396 01838/B
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
HALF LOAD BUTTON
Half load cycle can be used
for the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program. The “Half Load”
option can be used with the
programs indicated in the
table of programs.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
ADP 5600
Options and display description
Quick reference guide

Summary

Quick Reference Guide

Control Panel Overview

Details on program selection, start/resume, and cancel buttons for operating the appliance.

Display Indicators and Options

Explanation of salt, rinse aid indicators, half load, delayed start, and tablet settings.

Water Hardness and Salt Management

Setting Water Hardness (First Time Use)

Guide to setting water hardness levels for optimal cleaning results.

Salt Reservoir and Indicators

Instructions for filling the salt reservoir and understanding salt indicators.

Rinse Aid and Detergent Usage

Rinse Aid Adjustment and Indicators

How to add rinse aid, adjust dosage, and check indicators.

Detergent Addition and Tablet Use

Guidance on adding detergent, including specific notes for tablet usage.

Loading the Dishwasher Racks

Upper Rack Loading and Adjustment

Instructions for loading the upper rack, adjusting height, and removing it.

Lower Rack Loading

Guidance on loading the lower rack, including plate holders and cutlery basket.

Operating the Dishwasher

Program Selection and Washing Cycle

How to select programs, start, pause, cancel, and restart the wash cycle.

Switching Off and Basic Maintenance

Procedure for switching off the appliance and cleaning filters.

Troubleshooting Common Issues

Appliance Not Starting or Indicator Errors

Solutions for appliance not starting and CANCEL/Off indicator errors.

Crockery Cleaning and Reset Procedure

Addressing unclean dishes and how to reset the appliance after faults.

Crockery and Cutlery Troubleshooting

Drying and Spotting Issues

Resolving problems with dishes not drying, spots, and discolouration.

Residue, Marks, and Suds

Troubleshooting salt residue, rust marks, streaks, and excessive suds.

Safety, Precautions, and Disposal

General Precautions and Energy Saving

Guidelines on energy saving, child safety, and general appliance precautions.

Resistance to Frost, Disposal, and Declarations

Information on frost protection, proper disposal, and compliance declarations.

Whirlpool ADP 5600 Specifications

General

Brand	Whirlpool
Model	ADP 5600
Category	Dishwasher
Language	English