Whirlpool AWE 9725 - Page 3

SERVICE
Whirlpool Europe AWE 9725 07.11.2006 / Page 3
Customer Service 8593 972 10057 Doc. No: 4812 722 26957
Technical data
Drain pump (synchronous)
Type 68882/292079
Nominal/max. current 0.3/0.5/ A
0.2/0.22 A
Nominal power 30/26 W
Rotation speed 3000 rpm
Resistor (coil) (25 ˚C) 164/ Ω ± 7%
224 Ω ± 5%
Capacity 14 ± 2 l/min
Position of draining hose
outlet min. 0.9 m
max. 1.25 m
Control board
Type OMEGA
Timer basic 4619 710 90281
Timer programmed 4619 751 54431
Motor
Type MCA 52/64 - 148/ALE
Belt ratio i = 1:13.3
Resistance contacts (20 ˚C)
Stator (full field) 2.17 Ω ± 7%
Stator (tapped field) 1.35 Ω ± 7%
Rotor 1.90 Ω ± 7%
Tachogenerator 68.70 Ω ± 7%
Input power (230 V AC)
Washing 240 W ± 7%
Rinsing 350 W ± 7%
Spinning (full field) 320 W ± 10%
Spinning (tapped field) 400 W ± 10%
Radio interference supression
Rated voltage 90 - 250 V
Rated current 16 A
Frequency 50/60 Hz
Nominal capacity 680 nF X1 + 2 x 22 nF Y
± 20%
Nominal inductance 2 x 1 mH-30+50%
Nominal resistance 680 kΩ± 10%
Derivation current
(u = 250 V AC) ≤ 4.15 (2 x 2.075) mA
Drum up sensor
Nominal voltage 5 V DC
Nominal current 0,5 mA
Poles 1
Resistance 150 mΩ
Connection Wires + RAST 2.5
Distrubution actuator
Motor:
Nominal voltage 230 +10% -15% V
Nominal current 13 ± 5mA
Nominal resistance (20 ˚C) 6.5 kΩ± 10%
Contacts:
Nominal current 1 mA
Nominal voltage 24 V
Display module
Type DM LCDE
WH03 TL OM
12NC 4619 730 71103
Programs 11
Push button switch
Favorites
Easy ironing
Eco
Pre wash
Intensive rinse
Rinse hold
Selector
Temperature +/-
Spin/Start delay