To Next PageTo Next PageHow to fix vibration or off-balance in my Whirlpool Washer?
To address vibration or off-balance issues with your Whirlpool Washer, ensure that both the front and rear feet are firmly touching the floor, and the washer is level. Also, make sure the jam nuts are tightly secured against the bottom of the cabinet. If the floor is uneven, placing a 3/4" (19 mm) piece of plywood under the washer might help reduce noise.
Why my Whirlpool Control Panel will not power up?
If your Whirlpool Control Panel isn't powering up, with no keypad response or LED display, first check the power at the outlet, circuit breaker, fuses, and junction box connections. It may be due to no power to the dryer.
Why is my Whirlpool Washer vibrating, rocking, or “walking”?
Your Whirlpool Washer might be vibrating, rocking, or “walking” due to several reasons: * The feet may not be in contact with the floor and locked, so ensure the front and rear feet are in firm contact with the floor, and the washer is level. * The washer may not be level. Inspect the floor for flexing or sagging. If the flooring is uneven, placing a 3/4" (19 mm) piece of plywood under the washer can help reduce the sound.
What to do if my Whirlpool Washer is not draining or spinning properly?
If your Whirlpool Washer isn't draining or spinning and loads are still wet, first, empty pockets and use garment bags for small items. Cycles with lower spin speeds remove less water than cycles with high spin speeds, so use the recommended cycle/speed spin for your item. Tightly packed loads may not allow the washer to spin correctly; evenly arrange the wet load for balanced spinning and select RINSE & SPIN to remove excess water. Check the drain hose for proper installation, ensuring it doesn't extend into the standpipe farther than 4.5" (114 mm). Securely attach it to the drainpipe or tub, and do not tape over the drain opening. Lower the drain hose if the end is higher than 96" (2.4 m) above the floor. Remove any clogs from the drain hose.
How to stop my Whirlpool cabrio Washer from vibrating?
To address vibration, rocking, or “walking” in your Whirlpool Washer, ensure the front and rear feet are firmly in contact with the floor, and the washer is level. Tighten the jam nuts against the bottom of the cabinet. If the flooring is uneven, placing a 3/4" (19 mm) piece of plywood under the washer may help reduce noise.
What to do if the error code appears and the Whirlpool cabrio Washer has stopped?
If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE. Allow the washer to continue the load-balance correction routine.
How to fix Whirlpool Control Panel that will not heat?
If your Whirlpool Control Panel is not heating, verify proper dryer installation. Also, perform ACU L1 and L2 tests under Service Test Mode and check for L1 and L2.
What to do if Whirlpool Control Panel is leaking water?
If water is leaking from your Whirlpool Control Panel (on some models) due to too much water being dispensed during steam cycles, unscrew the nozzle and clean it if necessary to remove any residue buildup on the water nozzle opening.
Why is my Whirlpool Washer not cleaning clothes properly?
If your Whirlpool Washer is not cleaning or removing stains effectively, it's important to ensure the wash load is not overloaded. The washer senses the load size and adds the correct amount of water, which is normal for clothes to move freely. Avoid adding extra water, as this can lift items off the washplate, reducing cleaning effectiveness. Load items in loose heaps evenly around the washplate, and only add 1 or 2 additional items after the washer has started.
What to do if my Whirlpool cabrio displays a PF (power failure) error?
To address a PF (power failure) error on your Whirlpool Washer, touch START to continue the cycle or touch POWER to clear the display. This usually happens if a power failure occurred while the washer was running.
General| Wash Cycles | 12 |
|---|---|
| Energy Star Certified | Yes |
| Color | White |
| Steam Function | Yes |
| Type | Top Load |
