Whirlpool CAE2795 - User Manual

PAGE 1
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
PART NO. W10838047A
IMPORTANT SAFETY NOTICE — “For Technicians only”
This service data sheet is intended for use by persons having electrical, electronic, and
mechanical experience and knowledge at a level generally considered acceptable in the
appliance repair trade. Any attempt to repair a major appliance may result in personal injury
and property damage. The manufacturer or seller cannot be responsible, nor assume any
liability for injury or damage of any kind arising from the use of this data sheet.
Diagnostic Guide .................................................. 2
Activating the Service Diagnostic Test Modes ...... 2
Service Diagnostic Test Modes ......................... 3–5
Customer Viewable Fault Codes ..........................5
Service Fault / Error Codes ...............................6, 7
Quick Overview Tests ............................................ 8
CONTENTS
Manual Overview Tests ......................................... 9
Troubleshooting Guide ................................. 10, 11
Troubleshooting Tests ................................... 12–18
Main Control Connectors & Pinouts ................... 12
Component Locations & Washer Specs ............19
Wiring Diagram ................................................... 20
IMPORTANT: Electrostatic Discharge (ESD) Sensitive Electronics
ESD problems are present everywhere. Most people begin to feel an ESD discharge at
approximately 3000V. It takes as little as 10V to destroy, damage, or weaken the main control
assembly. The new main control assembly may appear to work well after repair is finished,
but a malfunction may occur at a later date due to ESD stress.
 Use an anti-static wrist strap. Connect wrist strap to green ground connection point
or unpainted metal in the appliance
– OR –
Touch your finger repeatedly to a green ground connection point or unpainted metal
in the appliance.
 Before removing the part from its package, touch the anti-static bag to a green ground
connection point or unpainted metal in the appliance.
 Avoid touching electronic parts or terminal contacts; handle electronic control assembly
by edges only.
 When repackaging main control assembly in anti-static bag, observe above instructions.
Voltage Measurement Safety Information
When performing live voltage measurements, you must do the following:
 Verify the controls are in the off position so that the appliance does not start when energized.
 Allow enough space to perform the voltage measurements without obstructions.
 Keep other people a safe distance away from the appliance to prevent potential injury.
 Always use the proper testing equipment.
 After voltage measurements, always disconnect power before servicing.
COMMERCIAL WASHERS, MODELS CAE2745, CAE2765,
CAE2795, QCAE2735, MAT20CS, MAT20MN

Summary

Safety Information

Electrical Hazard Warnings

Critical warnings about shock hazards and safe servicing practices.

Voltage Measurement and ESD Safety

Guidelines for safe voltage checks and handling of sensitive electronic parts.

Diagnostic Guide and Activation

Activating Service Diagnostic Test Modes

Fault Code Procedures

Fault Code Display Mode

Fault;Error Code Display Method

Troubleshooting Guide

Common Problem Diagnosis

Component Testing Procedures

Main Control and Pinout Testing

Checks the main control board, its power supplies, and connector pin assignments.

Valve and Shifter System Testing

Motor System Testing

Diagnoses the drive motor, its windings, relay, capacitor, and related harnesses.

Console, Thermistor, and Water Level Testing

Drain Pump and Lid Lock Testing

Procedures to test the drain pump and the lid lock mechanism.

Wiring Diagram

Wiring Diagram (Figure 9)

Provides a detailed schematic of the washer's electrical connections and components.

Whirlpool CAE2795 Specifications