Whirlpool DDLX 70113 - User Manual

Questions and Answers

M
Mark Davila DDSAug 7, 2025
What to do if my Whirlpool Washer dryer does not start?
- R
  Rebecca CooperAug 7, 2025
  If your dryer isn't starting, check these things: First, make sure the door is fully closed until you hear a click. Second, verify that the key lock is not activated by pressing and holding the key symbol button until the display indicates the keys are unlocked. Finally, ensure the plug is properly inserted and there's no power failure or blown fuse. Try plugging another appliance into the socket to check.
W
william22Aug 11, 2025
What to do if the “Bottom Filter” light is on in my Whirlpool DDLX 70113?
- M
  Melissa MooreAug 11, 2025
  If the “Bottom Filter” light is on, the bottom filter may be blocked by lint. Clean the bottom filter and ensure it is properly inserted afterwards. Also, push in the bottom filter and move the release levers into a vertical position to ensure the filter is correctly inserted in the filter compartment. Close the flap.
G
Gregory RoseAug 17, 2025
Why does my Whirlpool DDLX 70113 Washer drying take so long?
- C
  Connie DanielAug 17, 2025
  Several factors can cause prolonged drying times. Ensure you've selected the appropriate program for your laundry type. Clogged door or bottom filters can also extend drying time, so clean them according to the care and maintenance instructions. Also, laundry spun at speeds below 800 rpm might cause the water tank to fill quickly. High ambient temperatures, ideally, it should be between 15 and 20°C, can also affect drying, so air out the room if it's too warm. Lastly, the 'Gentle option' should only be used for small loads.
T
Tyler FoleyAug 22, 2025
Why are there water droplets beneath my Whirlpool DDLX 70113?
- A
  archerjeanAug 22, 2025
  If you notice water droplets beneath the dryer, several factors could be at play. Start by checking the bottom filter to ensure it's correctly inserted and fully integrated into its compartment. Remove any lint residue from the rubber seals of both the bottom filter and the door seal. Ensure the water tank is properly inserted into its compartment. Verify that the direct drain connection is functioning correctly, allowing water to drain effectively. Lastly, confirm that the dryer is standing level; if needed, adjust the dryer feet.
J
jeremyjonesAug 27, 2025
How to fix the “Door Filter” light on my Whirlpool Washer?
- J
  Juan CookAug 27, 2025
  If the “Door Filter” light is illuminated, it indicates that the door filter may be blocked by lint or not correctly positioned. Remove and clean the door filter, then ensure it is properly inserted so that it completely integrates into the filter compartment. Also, check the position of the door filter and ensure that it is properly inserted in the filter compartment.
L
Lindsay PaceSep 1, 2025
What to do if the empty “Water Tank” light is on in my Whirlpool DDLX 70113 Washer?
- J
  jackguzmanSep 1, 2025
  If the “Water Tank” light is illuminated, the water tank may be filled with water. Empty the water tank and ensure it is correctly positioned in the tank compartment.