30
Below is a summary of possible failure causes and
solutions.
If the problem persists after having followed the
instructions as indicated below. If afterwards the failure
indication still appears, switch o and unplug the dryer
and contact our After-Sales Service.
Display message Possible Cause Solution
F01 to F04 Failure of a component Turn the programme selector to 0/OFF then at
least wait for 3 seconds.
F05 to F09 Failure of a component Switch off and unplug the dryer. Immediately
open the door and take out the laundry, so
that the heat can dissipate.
Make sure that the ambient temperature ranges
between 5°C and 35°C. Wait for about an hour.
Plug in the dryer, load the laundry and start the
programme again.
If the failure persists, call the After-Sales Service.
F10 to F24 Failure of a component Switch off and unplug the dryer. Wait for about
half an hour. Plug in the dryer and start the
programme again.
If the failure persists, call the After-Sales Service.
To Next Page
Loading...
