Why does my Whirlpool Washer leak water?
Your Whirlpool Washer might be leaking water due to several reasons: the water intake hose may not be tightened properly, the detergent dispenser could be clogged, or the drain hose might not be properly fastened.
What to do if my Whirlpool FWD91296WS Washer is locked and the display flashes an error code?
If your Whirlpool Washer is locked and displaying an error code, shut off the machine, disconnect the plug from the outlet, and wait about 1 minute before turning it back on.
Why is my Whirlpool Washer not draining or spinning?
Your Whirlpool Washer might not be draining or spinning because the program does not include the draining function and with certain programs it must be activated manually. Also, the drain hose could be bent, or the drain line may be obstructed.
What to do if my Whirlpool FWD91296WS does not fill with water?
If your Whirlpool Washer is not filling with water, make sure the water intake hose is connected to the tap and is not bent. Ensure the water tap is open, the mains water supply has not been shut off, and there is enough pressure.
Why won't my Whirlpool Washer turn on?
Your Whirlpool Washer might not turn on because the plug is not inserted into the electrical outlet properly, there has been a power failure, or the door is not fully closed.
Why is my Whirlpool FWD91296WS Washer vibrating excessively during the spin cycle?
Excessive vibration during the spin cycle of your Whirlpool Washer can occur if the drum was not properly unblocked at the time of installation, if the washing machine is not level, or if the washing machine is squeezed between furniture and the wall.
What to do if my Whirlpool FWD91296WS Washer loads and drains water continuously?
If your Whirlpool Washer loads and drains water continuously, check if the “Start/Pause” button has not been pressed. Ensure the drain hose has been installed at 65 to 100 cm from the ground and that the end of the drain hose is not immersed in water. Also, verify the drain connector on the wall has an air vent.
Why won't the wash cycle start on my Whirlpool Washer?
The wash cycle on your Whirlpool Washer might not start because the “ON/OFF” button or the “Start/Pause” button has not been pressed. Also, the water tap might not be open, or a “Start delay” has been set.
Why is my Whirlpool FWD91296WS forming too much foam?
Too much foam in your Whirlpool Washer could be due to using a detergent that is not compatible with washing machines; it must bear the wording “for washing machines”, “for hand washing and washing machines”, or something similar. It may also be because the detergent dosage was excessive.
General| Brand | Whirlpool |
|---|---|
| Model | FWD91296WS |
| Loading type | Front loading |
| Maximum spin speed | 1200 RPM |
| Washing capacity | 9 kg |
| Capacity | 9 kg |
| Energy efficiency class | A+++ |
| Color | White |
| Energy Star Certified | No |
| Number of Wash Cycles | 14 |
| Noise Level | 52 dB |
| Width | 595 mm |
| Height | 850 mm |
| Depth | 640 mm |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
To Next Page