What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer will begin agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita-
tion starts, the Cycle Control Knob turns
clockwise until it points to OFF and the cycle
ends.
The washer pauses briefly throughout
each cycle. These
pauses are normal for
washer operation.
NOTE:
A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the Regular and Permanent
Press cycles.
WASH RINSE
Wash’
*Agitation speed is reduced in the last
few minutes of most cycles. This provides
better fabric care.
Drain (or partial drain*)
No agitation
‘The Permanent Press cyde partially
drains, fills, agitates briefly, and drains.
Soin
E
w
Rinse
u
-+- Drain-No agitation
w
Spin-S*y rinse
Ia
Spin
Inl
off
MAGIC CLEAN lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water pass over the filter, separat-
ing the lint from the water. The lint is then
spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
MA& CLEAN
Bidet
lint fitter
interior
11
To Next Page
Loading...
