PROBLEM
Washer will not fill
CHECK THE FOLLOWING
Are the water supply hoses kinked?
Is the Cycle Control Kncb set and pulled out?
Washer does not spln
Is the lid closed?
Washer stops during
Washer pauses briefly at different times in each cycle. These
a cycle
pauses are normal.
Washer fills and
Is the Cycle Control Knob pointing to a number in the cycle?
dralns without runnlng
Washer drains during
Adjust the drain hose so that it is higher than the water level in
wash and rinse cycles,
the washer. Is the dryer door firmly closed?
or water siphons out
Dryer will not run
Is the dryer door firmly closed?
Did you firmly push the Start Button?
Are the controls set in an ON position?
Dryer will not heat
Is the cycle in the last few minutes7 (there is no heat during
that time.)
If you have a gas dryer, are the valves open on both the dryer
and the supply line?
Drylng time too long
Is your lint screen clean? (See the Slow drying” section of the
table on page 31 for additional information.)
Is your exhaust duct or outside exhaust hood clogged with lint’?
34
To Next Page
Loading...
