The water dispenser
Chilled water comes from a tank behind
the meat drawer. It holds approximately
1% quarts (1.5 L).
When the refrigerator is first hooked up,
press the water dispenser bar with a sturdy
glass or jar until you draw and discard 2 to
3 quarts (1.9 to 2.8 L). The water you draw
and discard rinses the tank and pipes.
Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dis-
penser is designed to evaporate small
spills. There is no drain in this tray. Do not
pour water into it.
To dispense water:
1. Press a sturdy glass against the water
dispenser bar.
Models
TS22AW and TS25AW
(ice and
water)
1
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week
to maintain a fresh supply.
Using the automatic ice maker
Here are a few things you will want to know
about your automatic ice maker:
l The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically.
UP to shut off the ice maker.
NOTE: Do not turn ice maker on until it is
connected to the water supply. Instruc-
tions for ice maker water supply hook
up are attached to the back of the
refrigerator cabinet.
l It is normal for ice crescents to be at-
tached by a corner. They break apart
easily.
l The ice maker will not operate until the
freezer is cold enough to make ice. This
can take overnight.
l If ice is not being made fast enough and
more ice is needed, turn the Refrigerator
Control toward a higher number. Wait a
day and, if necessary, turn the Freezer
Control toward C.
14
To Next Page
Loading...
