ENQuick Guide
1
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.whirlpool.eu/register
CONTROL PANEL
FIRST TIME USE
1. On-O / Reset button with indicator light
2. Program selection button with indicator light
3. Multizone button with indicator light
4. Turbo button with indicator light / Keylock
5. Eco program indicator light
6. Keylock indicator light
7. Display
8. Program number and remaining time
indicator
9. Tablet (Tab) indicator light
10. Closed water tap indicator light
11. Rinse Aid rell indicator light
12. Salt rell indicator light
13. Power Clean® button with indicator light
14. Tablet (Tab) button with indicator light
15. Delay button with indicator light
16. Start/Pause button with indicator light /
Drain out
PROGRAMS TABLE
Before using the appliance carefully read the Safety Instruction.
PLEASE SCAN THE QR CODE ON YOUR
APPLIANCE IN ORDER TO HAVE MORE
DETAILED INFORMATION
1
16
5432 876 11109 141312 15
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and on
the machine’s functional components.
• It is mandatory that the salt reservoir never be empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher and must be
lled when the SALT REFILL indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the reservoir cap
(anticlockwise).
2. Position the funnel (see gure) and ll the salt reservoir
right up to its edge (approximately 1 kg); it is not unu-
sual for a little water to leak out.
3. Only the rst time you do this: ll the salt reservoir
with water.
4. Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get into
the container during the wash program (this could damage the water
softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the proce-
dure before the beginning of the washing cycle to avoid corrosion.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse
aid dispenser A should be lled when the
RINSE AID REFILL indicator light in the
control panel is lit.
NEVER pour the rinse aid directly into the
appliance tub.
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C. Introduce the
detergent into the dry dispenser D only. Place the amount of detergent for
pre-washing directly inside the tub.
If all-in-one detergents are used, we recommend using the TABLET button,
because it adjusts the program so that the best washing and drying results
are always achieved.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
WATER SOFTENING SYSTEM
Water softener automatically reduces water hardness, consequently pre-
venting scale buildup on heater, contributing also to better cleaning e-
ciency. This system regenerates itself with salt, therefore it is required
to rell salt container when empty.
Frequency of regeneration depends on water hardness level setting - regen-
eration takes place once per 6 Eco cycles with water hardness level set to 3.
Regeneration process starts in nal rinse and nishes in drying phase, be-
fore cycle ends.
• Single regeneration consumes: ~3.5L of water;
• Takes up to 5 additional minutes for the cycle;
• Consumes below 0.005kWh of energy.
A
C
D
Program Programs description
Drying
phase
Natural-
Dry
Available
options
*)
Duration
of wash
program
(h:min)
**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1.
Eco 50°- Program is suitable to clean normally soiled
tableware, that for this use, it is the most ecient pro-
gramme in terms of its combined energy and water con-
sumption, and that it is used to assess compliance with
the EU Ecodesign legislation.
3:10 9.5 0.85
2.
6
th
Sense® 50°- 60°- For normally soiled dishes with dried
food residues. Senses the level of soiling on the dishes
and adjusts the program accordingly.
1:25 - 3:00 7.0 - 14.0 0.90 - 1.40
3.
Intensive 65° - Program recommended for heavily soiled
crockery, especially suitable for pans and saucepans.
2:50 16.0 1.60
4.
Fast Wash&Dry 50° - Normally soiled crockery. Everyday
cycle, that ensures optimal cleaning and drying perfor-
mance in shorter time.
1:25 11.5 1.10
5.
Crystals 45° - Program for delicate items, which are more
sensitive to high temperatures, for example glasses and cups.
1:40 11.5 1.20
6.
Rapid 30’ 50° - Program to be used for half load of lightly-
-soiled dishes with no dried food residues. Without drying.
-
-
0:30 9.0 0.50
7.
Silent 50° - Suitable for night-time operation of the ap-
pliance. With the lowest noise.
3:30 15.0 1.15
8.
Sanitizing 65° - Normally or heavily soiled crockery, with
additional antibacterial wash. Can be used to perform
maintenance of the dishwasher.
-
1:40 10.0 1.30
9.
Prewash - Use to refresh crockery planned to be wa-
shed later. No detergent to be used with this program.
-
-
0:12 4.5 0.01
10.
Self- Clean
65° -
Program to be used to perform mainte-
nance of the dishwasher, to be carried out only when the
dishwasher is EMPTY using specic detergents designed
for dishwasher maintenance.
-
-
0:50 8.0 0.85
To Next Page
Need help?
General
Weight and Dimensions
