To Next PageTo Next Page
Need help?Do you have a question about the Whirlpool WDT710PAYB and is the answer not in the manual?
General| Brand | Whirlpool |
|---|---|
| Model | WDT710PAYB |
| Category | Dishwasher |
| Language | English |
Explains DANGER and WARNING safety alert symbols and their implications.
Warns about the tip-over hazard and provides precautions.
Outlines essential safety steps and professional installation requirements.
Lists all necessary tools and parts for the installation process.
Details site requirements, clearances, and floor leveling for optimal installation.
Provides a chart of product dimensions and cabinet opening requirements.
Highlights the shaded areas within cabinet walls for utility connections.
Details requirements for the drain hose, including length and connection.
Outlines requirements for the hot water supply line.
Specifies requirements for connecting a power supply cord.
Details requirements for making a direct wire electrical connection.
Instructions for preparing the cabinet with existing utility connections.
Instructions for preparing the cabinet with new utility connections.
Steps for routing the power supply cable through the cabinet.
Instructions for routing the water supply line.
Steps to attach and flush the water supply line.
Steps to drill the hole and route the drain hose.
Connecting drain hose to disposer/tee without an air gap.
Connecting drain hose to disposer/tee with an air gap.
Warnings regarding tip-over and excessive weight hazards.
Instructions for attaching the insulation blanket to the tub.
Steps for removing and preparing access panels and terminal box.
Installing the strain relief for electrical connections.
Routing the power cord into the terminal box.
Connecting the ground wire and main power wires.
Securing the cord on strain relief and reinstalling the terminal box cover.
Measuring the cabinet opening for correct fit.
Adjusting the dishwasher's leveling legs to the correct height.
Installing brackets for countertop securing.
Installing brackets for side securing on hard surfaces.
Sliding the nut and ferrule onto the copper tubing for connection.
Connecting the 90° elbow fitting to the water supply line.
Verifying the correct placement of water and drain hoses.
Adjusting door spring tension for proper opening/closing.
Moving the dishwasher into the cabinet opening.
Aligning the door and checking/adjusting leveling legs.
Connecting the water supply line to the shutoff valve.
Connecting the drain hose to the dishwasher's drain connector.
Routing the direct wire cable and connecting ground/main wires.
Verifying alignment and preparing for securing by removing the rack.
Fastening the dishwasher securely to the countertop.
Checking inner spacing and door clearance, adjusting as needed.
Reinstalling the lower dish rack and removing protective towel.
Reinstalling the dishwasher's access panel and securing it.
Connecting the power supply cord to the grounded outlet.
Restoring power at the fuse box or circuit breaker.
Steps to take if the dishwasher does not operate correctly.
Tips on using rinse aid for optimal drying.
Explanation of the Start/Resume light behavior.
