OPERATIONAL REQUIREMENTS
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that the water hardness
setting is based on the actual water hardness in your house.
The factory setting is for average (3) water hardness.
• Switch on the appliance by pressing the ON/OFF button.
• Switch off the appliance by pressing the ON/OFF button.
• Hold down button START/PAUSE for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the ON/OFF button.
• The current selection level number and the salt indicator light both flash.
• Press button P to select the desired hardness level.
To Next Page
Loading...
