Whirlpool WPWADRGW785

Questions and Answers

J
Jessica MataAug 19, 2025
What to do if my Whirlpool WPWADRGW785 Washer won’t run or fill, or it stops working?
- C
  Cheryl RodriguezAug 19, 2025
  If your Whirlpool washer isn't running, filling, or stops mid-cycle, consider these potential causes: * Ensure both hoses are properly attached and have water flowing to the inlet valve, and that both hot and cold water faucets are fully turned on. * Check the inlet valve screens for clogs and inspect the inlet hoses for any kinks that might be restricting water flow. * Verify the washer is properly connected to a grounded 3-prong outlet and that the outlet has power. Avoid using extension cords or plugging into a GFI (Ground Fault Circuit Interrupter). * Check the electrical source or call an electrician to check if voltage is low. * Reset a tripped circuit breaker or replace any blown fuses. If problems persist, contact an electrician.
K
kathleenmorseAug 21, 2025
Why is water or suds leaking from the door or rear of my Whirlpool WPWADRGW785 Washer?
- S
  Stephanie TorresAug 22, 2025
  If you notice water or suds leaking from your Whirlpool washer's door or rear, it could be due to: * Using non-HE detergent or using too much HE detergent. Only use HE detergent, as suds from regular detergents can cause leaks. Always measure detergent according to the manufacturer's instructions based on your load size. * Residue buildup on the door glass. Clean the underside of the glass window periodically to prevent potential leaks. * Opening the door during “Add Garment.” Water can drip off the inside of the door when opened mid-cycle.
R
ryanmichelleAug 23, 2025
Why is the Clean Washer LED flashing on my Whirlpool WPWADRGW785 Washer?
- J
  James BrownAug 23, 2025
  The Clean Washer LED is flashing on your Whirlpool washer to remind you to run the Clean Washer with affresh® cycle after 30 wash cycles. Run the Clean Washer with affresh® cycle. If you don't, the LED will stop flashing after 3 more regular wash cycles, but will reappear after another 30 cycles.
R
Richard ValenciaAug 26, 2025
What does it mean if all detergent level status lights are lit on my Whirlpool WPWADRGW785 Washer?
- J
  Jacqueline WoodAug 27, 2025
  If all detergent level status lights are lit on your Whirlpool washer, it could indicate: * The detergent dispenser isn't securely in place. Try pulling out the dispenser, filling it with detergent, and sliding it back in. * A Detergent Level sensor error. Reset the system by touching POWER. If the LEDs remain lit, unplug the washer for 30 seconds, then plug it back in. If the problem persists, remove the cartridge and use single load dispensing until resolved.
S
Susan HudsonAug 28, 2025
Why is my Whirlpool Washer vibrating, rocking, or “walking”?
- C
  Carl RamirezAug 28, 2025
  Several factors can cause your Whirlpool washer to vibrate, rock, or move excessively: * Ensure the front and rear feet are firmly on the floor and the washer is level, with jam nuts tightened against the cabinet's bottom. * Check the floor for flexing or sagging. If the flooring is uneven, placing a ¾" (19 mm) piece of plywood under the washer can help reduce noise. Avoid raised wooden platforms. * An unbalanced or overly large load can also cause this issue. Avoid tightly packed loads and washing single items; balance single items like rugs or jackets with a few extra items. * Finally, check if the shipping bolts are still attached to the back of the washer. Refer to the Installation Instructions section “Remove transport bolts from washer”.
L
Lorraine CalhounAug 30, 2025
Why is my Whirlpool WPWADRGW785 beeping when START is touched?
- T
  Thomas MclaughlinAug 30, 2025
  If your Whirlpool washer beeps when you touch START, it's likely because the door isn't fully closed. Ensure the door is completely closed before starting a cycle.
L
Lisa LeSep 1, 2025
How to fix fill hoses that are not attached tightly on my Whirlpool WPWADRGW785 Washer?
- N
  Natalie RobinsonSep 1, 2025
  To address fill hoses that are not tightly attached on your Whirlpool washer: * Tighten the fill-hose connections. * Ensure all four fill-hose flat washers are properly seated. * Check that the drain hose is correctly secured to the drainpipe or laundry tub. * Inspect household plumbing for leaks or clogs in the sink or drainpipe. Water can back up from clogged drains. Check laundry tubs, drain pipes, water pipes, and faucets for leaks. * Remove any strainer or nylon stocking from the end of the drain hose if it's clogged.
C
Chad ThomasSep 3, 2025
What to do if my Whirlpool WPWADRGW785 Washer is leaking around the door?
- B
  Benjamin SchwartzSep 3, 2025
  If your Whirlpool washer is leaking around the door, it may be due to hair, lint, or other debris on the inner door glass preventing a proper seal with the rubber door seal. Clean the inner door glass and seal. See “Cleaning the Door Seal” in the “Washer Maintenance” section.
T
Taylor LawrenceSep 5, 2025
Why does my Whirlpool WPWADRGW785 make clicking or metallic noises?
- K
  Kenneth DodsonSep 5, 2025
  Clicking or metallic noises in your Whirlpool washer can be due to several reasons: * The door locking or unlocking. The door will lock, unlock, and lock again, producing 3 clicks after touching and holding START. This is normal. * Objects caught in the washer drain system. Empty pockets before washing, as loose items like coins can fall between the drum and tub or block the pump. You may need to call for service to remove these items. * Metal items on clothing, such as snaps, buckles, or zippers, touching the stainless steel drum. This is a normal occurrence.
E
Eric ShawSep 8, 2025
Why is the load in my Whirlpool Washer not completely covered in water?
- R
  rossamandaSep 8, 2025
  It is normal for an HE front load Whirlpool washer. The washer senses load sizes and adds the correct amount of water for optimal cleaning.

Whirlpool WPWADRGW785 Specifications

General

Appliance Category	Washer
Brand	Whirlpool
Model Number	WPWADRGW785
Product Type	Top Load Washer
Color	White
Energy Star Certified	Yes
Number of Wash Cycles	12
Depth	28 in
Width	27 in