What to do if my Whirlpool WRD 6030 B Cooktop shows ER 03 and beeps continuously?
If your Whirlpool Cooktop displays the error code ER 03 and emits a continuous signal, it's likely due to water or cooking utensils being present on the glass surface covering the control unit. To resolve this, clean the operating surface of the stove thoroughly.
What to do if my Whirlpool Cooktop displays error ER 47?
If your Whirlpool Cooktop displays the error code ER 47, it indicates a communication problem. Ensure the connection cable is correctly and functionally connected.
Why does my Whirlpool Cooktop show error ER 21?
If your Whirlpool Cooktop displays error code ER 21, it means the ambient temperature for the electronics is too high. Allow the cooking surface to cool down. Check the temperature verification of the control unit.
What does error ER 40 mean on my Whirlpool Cooktop?
If your Whirlpool Cooktop displays the error code ER 40, it indicates that the primary PTC is too hot. Disconnect the stove from the power supply system.
What does U 400 error mean on a Whirlpool Cooktop?
If your Whirlpool Cooktop displays the error code U 400, it means that the control unit is connected incorrectly. Connect the stove to the correct mains voltage.
What does ER 36 mean on my Whirlpool WRD 6030 B?
If your Whirlpool Cooktop displays error code ER 36, it indicates a short circuit or that the electronic board is turning off. Replace the electronic board.
What does error ER 22 mean on my Whirlpool Cooktop?
If your Whirlpool Cooktop displays error code ER 22, it indicates a short circuit or an error in key detection. Replace the electronic board.
What does ER 20 mean on a Whirlpool WRD 6030 B Cooktop?
If your Whirlpool Cooktop displays error code ER 20, it indicates a ^ C error. Replace the electronic board.
General| Width | 60 cm |
|---|---|
| Weight | 8.5 kg |
| Type | Gas |
| Burner Types | 1 Rapid, 1 Auxiliary |
| Gas Type | LPG/NG Convertible |
To Next Page