To Next PageTo Next Page
Need help?Do you have a question about the Whirlpool WVIID1058BKG and is the answer not in the manual?
General| Appliance Category | Washer |
|---|---|
| Brand | Whirlpool |
| Model | WVIID1058BKG |
| Capacity | 5.3 cu. ft. |
| Number of Wash Cycles | 12 |
| Delay Wash | Yes |
| Deep Water Wash Option | Yes |
| Quick Wash Cycle | Yes |
| Color | Black |
| Control Type | Electronic |
| Type | Top Load |
Washer stops due to failure in water supply, indicated by abnormal code.
Washer stops due to failure in draining, indicated by abnormal code.
Washer stops due to spin-dry issues like lid opening or safety switch activation.
Washer stops if lid is opened for more than 4 seconds during child lock mode.
Washer stops due to water level sensor malfunction or overflow.
Washer stops due to computer board failure, indicated by 'EP' code.
Abnormal failure of main control and frequency conversion communication.
Faults related to display board receiving main control signal, indicated by codes.
Indicates high current issue, possibly due to foam or motor problems.
Indicates an over-voltage condition affecting the computer board.
Indicates a low voltage condition affecting the computer board.
Indicates motor operation failure, check wiring harness and control board.
Indicates excessive leakage current, possibly requiring main control board replacement.
Indicates IPM hardware failure, potentially requiring main control board replacement.
Indicates water temperature sensor failure (EC2), check connections and components.
Indicates heating pipe failure (E6C or E7C), check connections and resistance.
Indicates door lock failure (U4), check door sensor and lock mechanism.
Indicates high temperature alarm (H) in the barrel for safety.
Circuit diagrams for different washer models (WVIID1058BKG, WVWD1050&950&850BKG).
Troubleshooting steps for power source issues, including fuse and motor checks.
Diagnosing problems with water flow, valve, or pressure.
Troubleshooting when water supply does not stop, checking sensor and valve.
Diagnosing issues when the wash cycle does not start.
Troubleshooting when water does not drain out from the tub.
Troubleshooting when the drain cycle takes too long.
Diagnosing why the spin drying cycle does not work.
Operation of the safety device and its impact on the spin-dry cycle.
Diagnosing buzzing or rattling noises during the water supply phase.
Troubleshooting buzzing or rattling noises during washing or rinsing.
Diagnosing buzzing, rattling, or clattering noises during spin-drying.
List of components and part numbers for Section A (e.g., lid, panel, sensors).
List of components and part numbers for Section B (e.g., tub, pulsator, screws).
List of components and part numbers for Section C (e.g., outer tub, hoses, pump).
List of components and part numbers for Section D (e.g., wiring, covers, boards).
List of components and part numbers for Section D (filters, boards, hoses).
Diagram showing exploded view of top and main body components (A-1 to A-25).
Diagram showing exploded view of drum assembly components (B-1 to B-12).
Diagram showing exploded view of outer tub and related components (C-1 to C-25).
Diagram showing exploded view of base, wiring, and internal components (D-1 to D-45).
