2
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools Needed:
Utility knife 1/4" hex-head ratchet
or open-end wrench
Level 9/16" open-end wrench
Pliers or slip-joint pliers Bucket
INSTALLATION REQUIREMENTS
LOCATION REQUIREMENTS
NOTE: If the washer/dryer and pedestal assembly are located in
a garage, 3" (76 mm) must be added under the pedestal so that
the washer/dryer is 18" (458 mm) above the garage oor.
Towel
Sponge
Parts Supplied:
Four #12 x 3/4" hex-head Drawer divider
sheet metal screws
Additional Items Needed:
1/4" nut driver
5/16" hex-head ratchet
or nut driver
To Next Page
Loading...
