Whirlpool XHPC155YC - Completing the Installation and Drawer Reassembly; Align Sides of Pedestal; Prepare Pedestal Feet

7
1"
(25 mm)
2. Prepare pedestal feet
Using a 1/4" hex head ratchet or open-end wrench, lower the
feet approximately 1" (25 mm) away from the bottom of the
pedestal.
1. Align sides of pedestal
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
3. Stand the washer/dryer upright
1. Move close to nal location
Tip the washer/dryer back to its upright position. Remove
any remaining packaging material. Set the pedestal box aside
for use if installing another pedestal. Once both the washer
and dryer have been installed, dispose of/recycle all packaging
material.
Level the washer/dryer
Follow the installation instructions that came with your model
to nish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
NOTE: Be sure to remove the transport bolts from the back
of the washer.
COMPLETE THE INSTALLATION